Filter
Top Products
6
4. Identify the Right Handrail (47), which has a large hole in
the left side. Feed the Wire Harness (21) into the hole in
the bottom of the Right Handrail and out of the large hole
in the left side. (Note: It may be helpful to use
needlenose pliers to pull the Wire Harness out of the
large hole.) Press a Handrail Cap (41) onto the lower end
of the Right Handrail as shown.
Insert the rectangular bracket on the Right Handrail (47)
into the top of the Right Upright (62) so the Handrail Cap
(41) is against the Right Upright. Attach the Right
Handrail and the Handrail Cap with three 1” Bolts (8) and
two Washers (57) as shown.
Do not tighten the Bolts
yet.
Attach the Left Handrail (not shown) as described above.
Note: There is not a wire harness on the left side.
5. Hold the Crossbar (34) between the Handrails (1, 47).
Attach the Crossbar with two Crossbar Screws (53).
Do
not tighten the Crossbar Screws yet.
Attach the ring on the end of the ground wire to the small
hole in the side of the Right Handrail (47) with a Silver
Ground Screw (104).
3. Insert a Plastic Shim (103) into each side of the post on
the right side of the Base (11). Next, orient the Right
Upright (62) as shown, and insert it into the Base.
Make
sure that the Wire Harness (21) does not fall into the
Right Upright. Be careful to avoid pinching the Wire
Harness.
Note: If necessary, tap the Right Upright with a
rubber mallet until it is fully seated in the Base. If the
Right Upright cannot be fully seated, remove the outer
Plastic Shim and then insert the Right Upright.
Attach the Right Upright (62) to the Base (11) with three
1” Bolts (8) and three Star Washers (9).
Do not tighten
the Bolts yet.
Assemble the Left Upright (not shown) in the same way.
Large
Hole
Bracket
41
47
62
21
62
This hole
must be
on this side.
21
103
8
9
34
Ground
Wire
1
53
104
53
47
3
4
5
9
57
57
11
8
8
8
8