Filter
Top Products
9
CAUTION: Before operating the
console, read the following precautions.
• Do not stand on the walking belt when turning
on the power.
• Always wear the clip (see the drawing below)
while using the treadmill. When the key is
removed from the console, the walking belt
will stop.
• Adjust the speed in small increments.
• To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids on
the console. Put only sealable water bottles in
the water bottle holders.
BATTERY INSTALLATION
The console
requires two
"AA" batteries
(not included).
Alkaline batter-
ies are recom-
mended.
To install bat-
teries, open
the battery
cover beneath
the console as
shown. Press
two batteries
into the console. Make sure that the negative (–)
ends of the batteries are touching the springs.
Close the battery cover, push up on the tab, and then
push the tab forward as shown in the inset drawing.
Make sure that the tab locks into place.
STEP-BY-STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in (see page 8).
Step onto the
foot rails of the
treadmill. Find
the clip attached
to the key, and
slide the clip
onto the waist-
band of your
clothes. Next,
insert the key
fully into the con-
sole. Test the clip by carefully taking a few steps
backward until the key is pulled from the console.
If the key is not pulled from the console, adjust
the position of the clip as needed.
DIAGRAM OF THE CONSOLE
Speed Control
Displays
Batteries
54
Note: If there is a thin sheet of clear plastic
on the face of the console, remove it before
operating the console.
Clip
Key
Tab
54