Filter
Top Products
DIAGRAM OF THE CONSOLE
|,
_p_ ON I p.p._cTl_J_ CW
spEED CON TROL
_¢__°EEO T_NING ZONES
Speed Control
Displays
CALSI FATCALSI SPEED DME IDISTANC_
D
ONI,qESET
f
HEART RATE TRAINING ZONES
M,AXF4T_N _4C _ 1_ r_ f_._ TIO e_l
._...J
/
BATTERY INSTALLATION
The console requires two "AA" batteries (not
included). Alkaline batteries are recommended.
To install batteries, open the battery cover under the
console as shown below. Press two batteries into the
battery com-
partment.
Make sure
that the neg-
ative (-)
ends of the
batteries are
touching the
springs.
Close the
battery cover.
Cover
STEP-BY-STEP CONSOLE OPERATION
If there is a thin sheet of clear film on the face of the
console, remove it.
Before operating the console, make sure that the
power cord is properly plugged in. (See HOW TO
PLUG IN THE POWER CORD on page 7.)
Next, step onto the foot rails of the treadmill. Find the
clip attached to the key (see the drawing above), and
slide the clip onto the waistband of your clothing. Test
the clip by carefully taking a few steps backward
until the key is pulled from the console. If the key
is not pulled from the console, adjust the position
of the clip as needed.
Follow the steps on page 9 to operate the console.
8