Filter
Top Products
55
56
57
SEAT ASSEMBLYMISC
21
58. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained
in HOW TO USE THE HOME GYM SYSTEM, beginning on page 22 of this manual.
Before using the home gym system, pull each cable a few times to be sure that the cables move
smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem.
IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight
is used. See the CABLE DIAGRAMS on page 26 and 27 of this manual for proper cable routing.
If there is any slack in the cables, you will need to remove the slack by tightening the cables.
See TROUBLE-SHOOTING AND MAINTENANCE on page 25.
55. Press two 3/4” Round Inner Caps (78) into
each Pad Tube (28).
Insert a Pad Tube (28) into the Rear Seat
Frame (16). Slide a Foam Pad (29) onto each
end of the Pad Tube.
Insert the other Pad Tube (28) into the Leg
Lever (15). Slide a Foam Pad (29) onto each
end of the Pad Tube.
56. Attach the Large Backrest (19) to the Leg
Press Upright (4) with two 1/4” x 2 1/2”
Machine Screws (64) and two 1/4” Washers
(37).
57. Insert a 1/4” x 2 1/2” Carriage Bolt (60)
through the center hole in a Seat Plate (41).
Attach the Seat Plate to the Seat (17) with
two 1/4” x 1/2” Screws (59).
Insert the 1/4” x 2 1/2” Carriage Bolt (60)
through the indicated hole in the Front Seat
Frame (8). Tighten a 1/4” Nylon Locknut (44)
with a 1/4” Washer (37) onto the Carriage
Bolt.
Attach the other end of the Seat (17) to the
Front Seat Frame (8) with a 1/4” Washer (37)
and a 1/4” x 2 1/2” Machine Screw (64).
37
4
19
64
17
59
60
8
37
44
41
64
16
15
78
29
28
78
29