Filter
Top Products
17
36. Slide a 5/16” Washer (8) onto a 5/16” x 2 3/4”
Bolt (11). Insert the Bolt through the indicated
hole in the Pivot Arm (101). The Bolt must
be inserted from the side shown. Fully tight-
en a 5/16” Nylon Jamnut (93) onto the Bolt.
Wrap the Military Press Cable (72) around a
3 1/2” Pulley (15). Attach the Pulley and a
Cable Trap (66) to the Pivot Arm (101) with
the 3/8” x 3 3/4” Bolt (88), a 3/8” Washer (9),
and a 3/8” Nylon Locknut (21). Be sure that
the Pulley is on the side shown and that
the Cable Trap is positioned to hold the
Cable in place.
37. See inset drawing A. Attach a 3 1/2” Pulley
(15) and a Cable Trap (66) to the upper hole
in a Long “U”-Bracket (57) with a 3/8” x 2”
Bolt (12) and a 3/8” Nylon Locknut (21). Be
sure that the Cable Trap is inside the Long
“U”-Bracket. Note: This may come pre-
assembled.
Route the Military Press Cable (72) through
the Long “U”-Bracket (57) and around the
3 1/2” Pulley (15). Be sure that the Cable is
in the groove of the Pulley and that the
Cable and Pulley move smoothly.
See inset drawing B. Slide the end of the
Military Press Cable (72) onto the end of the
indicated 5/16” x 2 3/4 Bolt (11). Thread
another 5/16” Nylon Jamnut (93) onto the
Bolt. Do not fully tighten the second
Jamnut. There must be room between the
two Jamnuts for the end of the Cable to
pivot.
37
CABLE ASSEMBLY
72
15
21
57
A
B
12
15
66
57
93
72
36
88
11
72
21
66
101
15
9
93
8
11