Filter
Top Products
This section explains how to adjust the weight system. See the EXERCISE GUIDELINES on page 22 for impor-
tant information about how to get the most benefit from your exercise program. Also, refer to the accompanying
exercise guide to see the correct form for each exercise.
Make sure all parts are properly tightened each time the weight system is used. Replace any worn parts immediate
-
ly. The weight system can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents.
17
CHANGING THE WEIGHT SETTING
To change the setting of a weight stack, insert a
Weight Pin (26) under the desired Weight (22). Insert
the Weight Pin so that the bent end touches the
weight stack. Turn the bent end down.
Note: Do not
use the Top Weight (25) by itself.
Note: Due to the cables and pulleys, the amount
of resistance at each exercise station may vary
from the weight setting. Use the WEIGHT
RESISTANCE CHART on page 19 to find the
approximate amount of resistance at each weight
station.
37
37
26
22
25
83
ATTACHING THE ACCESSORIES TO A PULLEY
STATION
Attach the Lat Bar (35) to the High Cable (55) at the
high pulley station with a Cable Clip (37). For some
exercises, the Chain (83) should be attached between
the Lat Bar and the Cable with two Cable Clips. Adjust
the length of the Chain between the Lat Bar and
the Cable so that the Lat Bar is in the correct start-
ing position for the exercise to be performed.
The Lat Bar (35) or the Handle Strap (not shown) can
be attached at either pulley stations in the same man
-
ner
.
Always engage the Lock Plate (not shown) when
using the low pulley station (see USING THE LOCK
LEVER below).
USING THE LOCK LEVER
When using the low pulley station, engage the Leg
Lever Pin (38) into the Leg Lever (8) and the Lock
Plate (73).
35
55
38
8
73
ADJUSTMENTS