Filter
Top Products
8
8. Press a 38mm Square Inner Cap (44) into the top
of a Press Arm (46). Press a 25mm Round Inner
Cap (49) into each end of the handle on the
Press Arm.
Attach the Press Arm (46) to one side of the
Press Frame (17) with two M8 x 62mm Bolts (22)
and two M8 Nylon Locknuts (3).
Assemble the other Press Arm (46) in the same
manner.
9. Identify the Right Arm (48) and the Left Arm (47).
Note the position of the welded bracket on each
Arm. Arm identification is very important for
step 10.
Note: The “V”-Pulleys (6), Long Cable Traps (50),
M10 x 60mm Bolts (7), and M10 Nylon Locknuts
(21) are pre-attached. These have been shown
disassembled for easy part identification.
10. Lubricate both axles on the Top Frame (55).
Press a 28mm x 63mm Plastic Bushing (74) into
the Right Arm (48). Slide the Right Arm onto the
right axle on the Top Frame (55). Note: Be care-
ful not to confuse the Right Arm with the Left
Arm (47); refer to step 9 to identify the Right
Arm. Be sure that the upper end of the Right
Arm is behind the indicated bracket on the
Top Frame.
Tap two 25mm Retainers (69) and a 25mm
Round Cover Cap (70) onto the right axle. Be
sure that the teeth on the Retainers bend
toward the Cover Cap, as shown in the inset
drawing.
Attach the Left Arm (47) in the same manner.
Press a 38mm Square Inner Cap (44) into the
lower ends of the Right and Left Arms (47, 48).
Wet the end of each Arm with soapy water, and
slide a Large Foam Pad (45) onto the Arm.
10
50
50
46
3
22
46
49
49
44
17
7
44
49
Bracket
Lubricate
45
47
55
48
74
45
44
69
70
6
6
48
47
Welded
Brackets
21
8
9
69
55
70