Filter
Top Products
34
82
33
87
88
TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight
rack, can stretch slightly after it is first used. If there is
slack in the cables, tighten them by removing the M10
x 45mm Bolt (33) and the M10 Nylon Locknut (34)
attaching the lower Pulley (87) and Cable Trap (88) to
the two Pulley Plates (82). Reattach the lower Pulley
and Cable Trap to a higher set of holes in the Pulley
Plates using the Bolt and Nylon Locknut.
22
4
21
MOVING THE BENCH
To move the weight bench, lift the Bench Leg (4) so
that the bench pivots onto the Wheels (21). Roll the
bench to the desired location and set the Bench Leg
down.