Filter
Top Products
9
12
13a
13b
13. Refer to drawing 13a. Press Square Bushings (21)
into one of the Weight Rests (19) and one of the
Weight Spotters (20) as shown. Pull out the
Adjustment Knobs (22) and slide the Weight Spotter
and the Weight Rest down over the right Uprights
(7, 8) as indicated.
Refer to drawing 13b. Secure the Weight Spotter
(20) and the Weight Rest (19) to the right Uprights
(7, 8) by tightening each of the three Adjustment
Knobs (22) into one of the adjustment holes in the
Uprights.
Assemble the other Weight Spotter (20) and Weight
Rest (19) to the left Uprights (7, 8) in the same
manner. Make sure both Weight Spotters and
both Weight Rests are at the same height.
11
3
1
70
68
68
21
21
22
22
7
7
8
8
22
22
20
20
19
19
6
6
7
8
57
1
2
570
70
68
68
68
4
3
56
8
Adjustment
Holes
8
11. Identify the two Rear Uprights (8), which are slightly
shorter than the Front Uprights (not shown).
Attach the Rear Uprights (8) to the Left and Right
Bases (1, 3) using four M10 x 78mm Bolts (70) and
four M10 Nylon Locknuts (68). Do not tighten the
Nylon Locknuts yet. Make sure the Uprights are
oriented exactly as shown, with the adjustment
holes on the indicated side near the bottom.
Press a 60mm Square Outer Cap (56) onto the end
of the Weight Guide Base (4).
Orient the Foot Plate (5) and the Weight Guide
Base (4) as shown. Attach the Foot Plate and the
Weight Guide Base to the Center Base (2) using
two M10 x 78mm Bolts (70) and two M10 Nylon
Locknuts (68). Do not tighten the Nylon Locknuts
yet.
12. Attach one of the Front Uprights (7) and two Joint
Plates (6) to the Left Base (3) using four M10 x
78mm Bolts (70) and four M10 Nylon Locknuts (68).
Make sure the Front Upright is oriented so that
the holes on the bottom of the Front Upright
and the holes in the Joint Plates line up. If they
do not line up, turn the Front Upright upside-
down. Do not tighten the Nylon Locknuts yet.
Make sure the Front Upright is turned so the
adjustment holes are facing the Rear Upright
(8).
Attach the other Front Upright (7, not shown) and
two Joint Plates (6, not shown) to the Right Base
(1) in the same manner.
Tap a 60mm Square Inner Cap (57) into each of the
Front Uprights (7).
21