Filter
Top Products
5. Press two 75mm Bushings (26) into the top and
bottom of the Safety Spotter (10).
Attach the two Safety Spotter Bumpers (34) to the
Safety Spotter (10) with two M10 x 25mm Button
Bolts (81), two M10 Washers (79), and two M10
Nylon Locknuts (77).
Pull the Knob (30) out as far as it will go. Slide the
Safety Spotter (10) onto the top of the Center
Upright (3) and engage the Knob into an adjust-
ment hole. Turn the Knob clockwise until tight.
Press a 60mm Square Inner Cap (46) into the top
of the Center Upright (3).
4
7
4. Attach the Center Upright (3) to the Center Base
(24) with two M10 x 75mm Bolts (73), four M10
Washers (79), and two M10 Nylon Locknuts (77).
Do not tighten the Nylon Locknuts yet.
3
3. Press two 2” Round Inner Caps (47) into the ends
of the weight tube on the Weight Carriage (25).
Press two 75mm Bushings (26) into the top and
bottom of the Weight Carriage.
Orient the Weight Carriage (25) and Center
Upright (3) so that the welded bolt and letters are
on the indicated sides. Slide the Weight Carriage
onto the bottom of the Center Upright.
Attach the Carriage Stop (27) to the indicated
hole in the Center Upright (3) with an M10 x
86mm Bolt (63) and an M10 Nylon Locknut (77).
2
22
77
77
24
53
53
50
1
90
90
23
5
77
3
63
47
47
Weight
Tube
Letters near
the top of
this side
Welded
Bolt
27
26
26
25
77
79
79
73
24
3
26
77
77
26
3
81
79
79
81
Adjustment
Hole
34
34
10
46
30
2. Press two 50mm Thick Square Inner Caps (53)
and a 2” x 3” Inner Cap (50) into the ends of the
Center Base (24).
Have a second person hold the Right and Left
Uprights (1, 2 [not shown]). Attach the Right and
Left Bases (22, 23) to the Center Base (24) with
two M10 x 97mm Bolts (90) and two M10 Nylon
Locknuts (77). Do not tighten the Nylon
Locknuts yet.