Filter
Top Products
12
21. Attach the indicated end of the Low Cable (8) to the
bracket on the Rear Base (3) using an M10 x 20mm
Bolt (26) and an M10 Nylon Locknut (11).
22. Make sure all parts are properly tightened
before you use the weight rack. The use of all
remaining parts will be explained in Adjusting the
Weight Rack beginning below.
21
26
11
3
8
Bracket
This section explains how the weight rack can be adjusted. Inspect and tighten all parts each time you use the
weight rack. Replace any worn parts immediately. The weight rack can be cleaned with a damp cloth and a mild,
non-abrasive detergent. Do not use solvents.
Adjusting the Weight Rack
USING THE LOCKING BAR
Before starting an exercise, position the barbell and the
Safety Spotters (23, 24) in the correct position for the
exercise.
To do this, stand in front of the rack and grip the
Locking Bar (34) with both hands. Turn the Locking Bar
until the two hooks disengage the slots in the Uprights
(1). Raise or lower the Locking Bar to a new position
and turn it until the hooks engage the slots in the
Uprights. Note: Always start an exercise with the
barbell positioned at the lowest point to which it
will move during the exercise.
Position both Safety Spotters (23, 24) directly under the
Weight Gliders (31, 32). (See USING THE SAFETY
SPOTTERS on page 13.)
USING THE WEIGHT ADAPTER
A Weight Adapter (42) and Pin (52) have been included
for use with the WEIDER
¨
PRO XT15 weight bench
(model number WEBE0910).
To use Olympic weights with the weight bench, slide the
Weight Adapter (42) onto the leg lever and secure it by
inserting the Pin (52) through the leg lever as shown.
24
32
31
Hook
Hook
23
34
1
1
Leg Lever
52
42