Weider WEBE13011 Home Gym User Manual


 
7
4
5
5. Press a Rubber Endcap (14) onto the end of an
Upright (2). Orient the Upright as shown and
attach it to an Upright Base (3) with two M10 x
19mm Bolts (22) and two M10 Washers (18).
Note: The Bolts must be attached to the low-
est set of holes in the Upright and Upright
Base. Do not tighten the Bolts yet.
Attach the other Upright (2) to the other Upright
Base (3) in the same manner. Note: Attach the
Uprights so that the name and pull-up decals
are in the indicated locations.
3
5
19
19
23
23
3
22
18
18
22
2
Name
Decal
Pull-up
Decal
Push-up
Decal
14
7
4. Attach an Angled Support (7) to a Stabilizer (5)
with an M10 x 68mm Bolt (23) and an M10 Nylon
Locknut (19). Attach the Angled Support to the
Upright Base (3) with another M10 x 68mm Bolt
and an M10 Nylon Locknut. Do not tighten the
Nylon Locknuts yet.
Attach the other Angled Support (7) to the other
Stabilizer (5) and Upright Base (3) in the same
manner.
3
19
23
23
3
3
15
3. Attach the Bottom Crossbar (15) to an Upright
Base (3) with two M10 x 68mm Bolts (23) and
two M10 Nylon Locknuts (19). Note: Attach the
Bottom Crossbar so that the indicated decal
is in the indicated location. Do not tighten the
Nylon Locknuts yet.
Attach the Bottom Crossbar (15) to the other
Upright Base (3) in the same manner.