Filter
Top Products
7
5. Orient the Left Upright (28) as shown and attach
it to the left Upright Base (2) with two M8 x 68mm
Bolts (24), two M8 W
ashers (23), and two M8
Nylon Locknuts (22).
Note: The Bolts must be
attached to the lowest set of holes in the
Upright and Upright Base. Make sure the bolt
heads fit inside the hexagonal holes in the
Upright Base. Attach the Upright so that the
name decal is in the indicated location. Do not
tighten the Locknuts yet.
Attach the Right Upright (3) to the other
Upright Base (2) in the same manner.
6. Attach a Dip Arm (5) to the Right Upright (3) and
Upright Base (2) with two M8 x 77mm Bolts (29),
a Support Plate (13), and two M8 Nylon Locknuts
(22). Do not tighten the Locknuts yet.
Repeat this step with the other Dip Arm (5)
and the Left Upright (not shown).
13
5
3
22
5
2
29
3
28
2
5
7.
Attach the Top Crossbar (7) to a Dip Arm (5) with
two M8 x 75mm Bolts (17), two M8 W
ashers (23),
and two M8 Nylon Locknuts (22).
Do not tighten
the Locknuts yet.
Attach the T
op Crossbar (7) to the other Dip
Arm (5) in the same manner.
2
22
23
23
Name
Decal
24
6
7
22
5
17
22
7
5
23
23