Filter
Top Products
10
14
26
14
36
31
41
45
25
25
2
31
16
31
17
17
34
25
24
26
27
24
14. Lift the High Cable (26) in the location shown.
Attach two Pulleys (25) inside the Weight Guide
Frame (14) using two M10 x 75mm Bolts (36), four
M10 Flat Washers (41), four 18mm Spacers (45),
and two M10 Nylon Locknuts (31).
15. Pull the High Cable (26) down in the indicated loca-
tion, so there is no slack at the ends of the High
Cable.
Locate the Low Cable (27), which is shorter and
has two balls on one end. Insert the metal-sleeve
end of the Low Cable into the indicated hole in the
Weight Guide Base (4). Attach the Low Cable using
an M10 x 75mm Bolt (36), two M10 Flat Washers
(41), two 28mm Spacers (44), and an M10 Nylon
Locknut (31).
Route the ball-end of the Low Cable (27) through
the bracket on the Center Base (2). Attach a Pulley
(25) inside the bracket using an M10 x 45mm Bolt
(34) and an M10 Nylon Locknut (31).
16. Hold a Pulley (25) in the High Cable (26) as shown.
Attach a Cable Trap (24) and the two Pulley Plates
(17) to the Pulley using an M10 x 45mm Bolt (34)
and an M10 Nylon Locknut (31).
Lay the Low Cable (27) over a Pulley (25) as
shown. Attach the Pulley and a Cable Trap (24) to
the Pulley Plates (17) using an M10 x 45mm Bolt
(34) and an M10 Nylon Locknut (31). Make sure
the Bolts are inserted through the highest and
lowest holes in the Pulley Plates. In addition,
make sure the Cables are between the Cable
Traps and the Pulleys.
41
41
41
45
45
45
34
36
41
41
44
4
44
27
26
15