Filter
Top Products
3. Press two 2 1/2” Square Bushings (22) into the
Weight Carriage (15). Press two 1” Round Inner
Caps (21) into the Weight Carriage.
Press a 2 1/2” Square Bushing (22) into the
Carriage Stop (18). The hole in the Square
Bushing must be aligned with the indicated hole
in the Carriage Stop.
4. Slide the Weight Carriage (15) onto the Upper Lat
Tower (41). The Weight Carraige must be orient-
ed as shown.
Slide the Carriage Stop (18) onto the Upper Lat
Tower (41). The 2 1/2” Square Bushing (22) must
be facing toward the Weight Carriage (15). Attach
the Carriage Stop to the Upper Lat Tower with an
M8 x 68mm Bolt (8) and an M8 Nylon Locknut (7).
Insert the Upper Lat Tower (41) into the Lower Lat
Tower (23). Fully tighten the M10 x 56mm Bolt (19)
into the Lower Lat Tower.
Slide a Weight Stop (45) onto each side of the
Weight Carriage (15).
5. Wrap the Cable (10) around a Pulley (9). Attach the
Pulley to the Upper Lat Tower (41) with an M10 x
70mm Bolt (12), two M10 Washers (13), two 14mm x
15mm Spacers (11), and an M10 Nylon Locknut (4).
Attach the other Pulley (9) in the same manner.
Attach the other end of the Cable (10) to the eye-
bolt on the Weight Carriage (15).
3
4
5
7
22
22
22
15
21
21
Align these
Holes
18
41
45
45
15
8
22
19
18
23
7
41
11
11
12
12
13
13
13
9
4
4
15
13
9
10