Filter
Top Products
3. Attach the Front Leg (8) to the Frame (2) with two
M10 x 65mm Bolts (18), two M10 Washers (24),
and two M10 Nylon Locknuts (19).
4. Tap three 45mm Square Inner Caps (21) into the
ends of the Leg Lever (4) as shown.
Tap a 1Ó Round Inner Cap (23) into the indicated
end of the Weight Tube (41).
Insert the Weight Tube (41) into the indicated hole
in the Leg Lever (4). Press a 1Ó Angle Cap (29)
onto the indicated end of the Weight Tube.
Note: If you purchased the optional olympic
expansion kit, attach the olympic sleeve to the
Weight Tube as shown in the accessory manu-
al.
5. Lubricate an M10 x 72mm Bolt (40). Attach the
Leg Lever (4) to the Front Leg (8) with the Bolt
and an M10 Nylon Locknut (19).
Attach the Spacer (37) to the Leg Lever (4) with
the M8 x 58mm Bolt (39), two M8 Washers (38),
and an M8 Nylon Locknut (13). Note: The Spacer
will fit tightly inside of the Leg Lever.
6. Press four 1Ó Square Inner Caps (12) into the indi-
cated ends of the Backrest Tubes (5, 42). Press
two 1Ó x 2Ó Inner Caps (36) into the ends of the
adjustment tubes.
With the wide end of the Backrest (6) positioned
as shown, attach the Backrest Tubes (5, 42) to
the Backrest with four M6 x 38mm Screws (16)
and four M6 Washers (25). Note: The Backrest
Tubes and Backrest must be oriented exactly
as shown.
7
3
18
24
2
19
8
19
21
21
21
41
4
29
23
4
4
38
39
38
37
13
19
40ÐLubricate
8
5
16
25
42
5
Adjustment
Tubes
12
12
16
16
36
6
Wide
End
6
25
25