13
24.
Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENTS, beginning on page 15.
Before using the resistance system, pull the long cable a few times to be sure that it moves smoothly over
the pulleys. If the cable does not move smoothly, find and correct the problem. IMPORTANT: If the cables
are not properly installed, they may be damaged when heavy resistance is used. See the CABLE
DIAGRAM on page 18 for proper cable routing.
20
62
23
89
75
92
75
90
35
31
35
20. Attach a 3 1/2” Pulley (89) inside of the hole in
the Front Leg (31) with a 3/8” x 3 1/2” Bolt (90),
two 1” Spacers (35), two 3/8” SAE W
ashers (75),
and a 3/8” Nylon Jamnut (92).
Make sure the
Pulley is above the Leg Lever Cable (62).
Slide the two free ends of the Leg Lever Cable
(62) onto the hook welded to the bottom of the
Bench Rail (23).
21. Slide two Foam Pads (28) onto the tube on the
Front Leg (31). Press two 3/4” Round Inner Caps
(33) into the ends of the tube.
Repeat this step with the Leg Lever (32).
21
28
33
32
31
28
33
22. Wrap a Short Cable (60) over a 3 1/2” Pulley
(89). Attach the Pulley to a High Pulley Housing
(52) with a 3/8” x 1 3/4” Button Bolt (25) and a
3/8” Nylon Locknut (73).
Repeat this step with the other Short Cable
(60) and High Pulley Housing (52).
23. Adjust the tension on the upper cable (not shown)
as described in UPPER CABLE
ADJUSTMENT
on the following page.
22
25
89
60
52
73