Filter
Top Products
4
ASSEMBLY
1
1.
Attach a Cap (2) to one end of the 200-pound
Resistance Bars (1) with a #8 x 1/2” Flat Head
Screw (3).
Repeat with the other Caps.
2. Locate the Tray (B) on the resistance system.
Remove the two indicated Button Head Screws (C)
and the Cover Plate (A) from the Tray.
Note: The
resistance bar assembly is shown removed
from the resistance system for clarity.
3. Remove the 80-pound Top Resistance Bar (D)
from the Cover Plate (A) by removing the two
Screws (E).
Before beginning assembly, make sure that
you have read and understand the informa-
tion in the box above.
3
3
2
2
2
2
1
C
B
A
A
D
E
Before beginning assembly, carefully read the
f
ollowing information and instructions:
• Assembly requires two persons.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• Make sure all parts are oriented as shown in the
drawings.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
The following tools (not included) are required
f
or assembly:
• One standard screwdriver
• One Phillips screwdriver
• One Allen wrench (included
with the MAX by WEIDER
resistance system)