Filter
Top Products
7. Attach the upper ends of the Long Weight
Guides (62) to the Top Frame (55) with a
5/16Ó x 6Ó Bolt (60), two 1/2Ó x 3/4Ó Spacers
(61), and a 5/16Ó Nylon Locknut (3).
Be sure that the Pulley Bracket (20) is in
front of the right Long Weight Guide (62)
as shown.
Attach the upper ends of the Short Weight
Guides (73) to the Top Frame (55) with a
5/16Ó x 6Ó Bolt (60), two 1/2Ó x 3/4Ó Spacers
(61), and a 5/16Ó Nylon Locknut (3).
8. Press a 1Ó x 7/8Ó Plastic Bushing (90) onto
each welded spacer on the Press Frame (17).
Slide the Press Frame into place onto the
Base (4). Note: This will be a tight fit. The
Plastic Bushings should fit on each end of
the indicated tube in the Base. Make sure
that the pulleys are on the side shown.
Lubricate the 3/8Ó x 8Ó Bolt (59). Attach the
Press Frame (17) to the Base (4) with the
3/8Ó x 8Ó Bolt and a 3/8Ó Nylon Locknut (21).
9. Wet the handle of one Press Arm (46) with
soapy water. Slide a 5Ó Plastic Grip (83) onto
the handle. Press a 1Ó Round Inner Cap (49)
into the other end of the handle. Press a
1 3/4Ó Inner Cap (44) into the Press Arm.
Attach the Press Arm (46) to one side of the
Press Frame (17) with two 5/16Ó x 2 1/2Ó
Bolts (22) and two 5/16Ó Nylon Locknuts (3).
Assemble the other Press Arm (46) in the
same manner.
10. Identify the Right Arm (48) and the Left Arm
(47). Note the position of the welded bracket
on each Arm. Arm identification is very
important for step 11.
Attach a ÒVÓ-Pulley (50) and a Long Cable
Trap (31) to the Right Arm (48) with a 3/8Ó x
2 1/2Ó Bolt (86) and a 3/8Ó Nylon Locknut
(21).
Attach a ÒVÓ-Pulley (50) and a Long Cable
Trap (31) to the Left Arm (47) in the same
manner.
7
8
9
10
ARM ASSEMBLY
FRAME ASSEMBLY
7
60
61
361
3
55
60
20
73
62
17
59
Lubricate
90
4ÑTube
21
Welded
Spacers
44
49
83
46
17
22
3
Handle
46
48
Welded
Bracket
47
50
50
31
31
86
21