Filter
Top Products
15
35. Route the Leg Lever Cable (96) through the Right
Upright (6) and around a 90mm Pulley (38).
Attach the Pulley inside the Upright with an M10 x
70mm Bolt (81), two M10 Washers (75), two
13mm Spacers (34), and an M10 Nylon Locknut
(70).
36. Wrap the Leg Lever Cable (96) around a 90mm
Pulley (38). Attach the Pulley and a Cable Trap
(91) to the second set of holes from the bottom of
the indicated Double “U”-Bracket (56) with an
M10 x 50mm Bolt (62) and an M10 Nylon Locknut
(70). Be sure the Cable Trap is turned to hold
the Cable in the groove of the Pulley.
34. Attach a 90mm Pulley (38) inside the Right Leg
(73) with an M10 x 70mm Bolt (81), two M10
Washers (75), two 13mm Spacers (34), and an
M10 Nylon Locknut (70).
33. Locate the Leg Lever Cable (96). Route the
eyelet end of the Cable through the Right Leg
(73) and attach it to the Leg Lever (4) with an
M10 x 25mm Shoulder Bolt (99) and an M10
Nylon Locknut (70).
73
4
70
99
96
33
34
34
81
73
38
75
75
70
34
75
34
38
6
96
81
34
35
96
62
38
91
56
70
36
75
70