Filter
Top Products
21
Miscellaneous Assembly
52. Insert a 1/4” x 2 1/2” Carriage Bolt (45) through the
center hole in a Seat Plate (65). Attach the Seat Plate
to a Seat (13) with two 1/4” x 3/4” Bolts (49).
Insert the 1/4” x 2 1/2” Carriage Bolt (45) into the indi-
cated hole in the Butterfly Seat Frame (14) and
secure it with a 1/4” Flat Washer (71) and a 1/4”
Nylon Locknut (68). Secure the other end of the Seat
(13) with a 1/4” x 2 1/2” Bolt (79) and a 1/4” Flat
Washer (71).
Attach the other Seat (13) to the Press Seat Frame
(7, not shown) in the same manner.
55. Attach the Curl Pad (105) to the Curl Post (104) with
two 1/4” x 3/4” Bolts (49).
52
49
68
65
13
71
14
71
79
45
55
104
105
49
53. Press 3/4” Round Inner Caps (43) into the ends of the
Pad Tube (42) and the indicated tube on the Front
Leg (20).
Insert the Pad Tube (42) into the indicated hole in the
Small Leg Lever (41). Slide Foam Pads (30) onto the
ends of the Pad Tube and the tube on the Leg Lever.
53
43
30
30
43
43
43
20
30
Tube
42
41
30
54. Press a 1 3/4” Square Inner Cap (35) into the indicat-
ed end of the Adjustment Tube (90).
Attach the Adjustment Tube (90) to the bracket (not
visible in the drawing) on the back of the Leg Press
Plate (55) with a 5/16” x 2 1/2” Bolt (87), two 5/16”
Washers (36), and a 5/16” Nylon Locknut (64).
Attach the Leg Press Plate (55) to the Leg Press
Lever (83) by placing the Adjustment Tube (90) into
the bracket on top of the Leg Press Lever and secur-
ing it with the Lock Pin (91). Note: The lip on the
Leg Press Plate must be on the upper edge.
54
35
87
36
90
36
91
64
55
83