Filter
Top Products
Before beginning assembly, carefully read the fol-
lowing information and instructions:
• Assembly requires two people.
• Because of its size, the weight bench should be
assembled in the location where it will be used.
Make sure that there is enough clearance to walk
around the weight bench as you assemble it.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• F
or help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
• As you assemble the weight bench, make sure all
p
arts are oriented as shown in the drawings.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• The included grease and the following tools (not
included) may be required for assembly:
Two adjustable wrenches
One rubber mallet
One standard screwdriver
One Phillips screwdriver
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
M
ake Things Easier for Yourself
Everything in this manual is designed to ensure
t
hat the weight bench can be assembled suc-
cessfully by almost anyone. By setting aside
plenty of time, assembly will go smoothly.
ASSEMBLY
6
2
1
17
17
37
Indents
13
8
3
W
arning
Decals
18
18
16
17
1
1
1.
Orient the Crossbar (3) so that the warning decals
are on top. Attach the Crossbar to an Upright (1)
with two M8 x 55mm Bolts (18), two M8 Washers
(16), and two M8 Nylon Locknuts (17);
do not
tighten the Nylon Locknuts yet.
Attach the Crossbar (3) to the other Upright
(1) in the same way.
2.
Orient the Stabilizer (13) so that the indented
holes are facing the floor. Attach the Front Leg (8)
to the Stabilizer with two M8 x 42mm Carriage
Bolts (37) and two M8 Nylon Locknuts (17);
d
o
not tighten the Nylon Locknuts yet.
Before assembling the weight bench,
make sure that you have read and under-
stand the information in the box above.