Filter
Top Products
5. Insert the Support Rod (14) into a set of holes in
the Uprights (1). Turn the Support Rod so the
l
ocking pin is wrapped around the Upright.
T
ighten the M10 Nylon Locknuts (31) and M10
x 19mm Screw (5) used in steps 1–5.
1
1
1
4
5
7
6. Lubricate the M10 x 60mm Bolt (25) with grease.
Attach the Leg Lever (6) to the Front Leg (4) with
the Bolt and an M10 Nylon Locknut (31).
Do not
overtighten the Locknut; the Leg Lever must
be able to pivot easily.
7. Slide a Pad Tube (12) into the Leg Lever (6).
Slide two Foam Pads (13) onto the ends of the
Pad Tube. Make sure the Foam Pads are ori-
ented as shown.
Repeat this step with the other Pad Tube (12).
6
13
13
12
12
Locking
Pin
25
31
Lubricate
6
4
6
7
8.
Insert a Weight Rest (15) into an Upright (1). Turn
the Weight Rest so the locking pin is wrapped
around the Upright.
Repeat this step with the other W
eight Rest
(15). Make sure that the Weight Rests are at
the same height.
15
15
Locking
Pin
1
1
8