Filter
Top Products
6
1. Before assembling this product, be sure that
you have read and understand the information
in the box above.
Position the Crossbar (3) with the warning decal
facing up as shown. Attach the Crossbar to the
Uprights (1) with four M8 x 65mm Bolts (14), two
Support Plates (28), and four hand-tightened M8
Nylon Locknuts (13). Note the position of the
name decal and make sure the Uprights are ori-
ented as shown.
Do not tighten the Nylon Locknuts (13) yet.
2. Insert a 38mm Square Inner Cap (21) into the
Front Leg (8).
Slide the welded tube on the Front Leg (8) into
the indicated hole in the Frame (2). Secure the
Front Leg with two M8 x 40mm Carriage Bolts
(26), two M8 Washers (29), and two M8 Nylon
Locknuts (13).
Before beginning assembly, carefully read the
following information and instructions:
¥ Place all parts of the weight bench in a cleared
area and remove the packing materials; do not
dispose of the packing materials until assembly
is completed.
¥ Read each assembly step before you begin.
¥ For help identifying the small parts used in
assembly, use the PART IDENTIFICATION
CHART on the previous page. Note: Some
small parts may have been pre-attached for ship-
ping purposes. If a part is not in the parts bag,
check to see if it has been pre-attached.
¥ Tighten all parts as you assemble them, unless
instructed to do otherwise.
¥ As you assemble the weight bench, make sure
that all parts are oriented as shown in the draw-
ings.
THE FOLLOWING TOOLS (NOT INCLUDED)
ARE REQUIRED FOR ASSEMBLY:
¥ Two (2) adjustable wrenches
¥ One (1) phillips screwdriver
¥ One (1) rubber mallet
¥ Lubricant, such as grease or petroleum jelly,
and soapy water will also be needed.
Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches, or a set of ratchet wrenches.
2
1
14
28
28
14
3
1
13
8
29
13
21
2
26
1
Name
Decal
Assembly