Filter
Top Products
8. Insert the Backrest Bracket (10) into the slot in
the Bench Frame (1).
Lubricate an M10 x 172mm Bolt (41) with grease.
Attach the Backrest Tubes (12) to the Bench
Frame (1) with the Bolt and an M10 Nylon Locknut
(48). Do not overtighten the Locknut; the
Backrest Tubes must be able to pivot easily.
8
6
48
34
51
47
30
47
42
21
Lubricate
16
3
2
6. Attach the Weight Tube (16) to the Leg Lever (3)
with an M8 x 58mm Bolt (42), two M8 Washers
(47), a 10mm Spacer (30), and an M8 Nylon
Locknut (51). Press a 25mm Round Angled Cap
(34) onto the end of the Weight Tube.
Lubricate an M10 x 72mm Bolt (21) with grease.
Attach the Leg Lever (3) to the Front Leg (2) with
the Bolt and an M10 Nylon Locknut (48). Do not
overtighten the Locknut; the Leg Lever must
be able to pivot easily.
7. Attach the Backrest Tubes (12) to the Backrest
Bracket (10) with four M8 x 43mm Bolts (27), four
M8 Washers (47), and four M8 Nylon Locknuts
(51). Do not tighten the Locknuts yet.
51
51
10
27
12
47
47
47
47
27
10
41
48
Lubricate
1
7
8
5
5. Attach the Bench Frame (1) to the center holes in
the Crossbar (4) with two M10 x 84mm Bolts (43)
and two M10 Nylon Locknuts (48).
Tighten the M10 Nylon Locknuts (48) used in
steps 1–5.
48
1
43
43
4
Center
Holes
12