Filter
Top Products
8
5. Attach the Bench Frame (3) to the Crossbar (2)
with two M10 x 68mm Bolts (27) and two M10
Nylon Locknuts (31).
Tighten the M10 Nylon Locknuts (31) used in
steps 1–5.
6. Press a 25mm Round Inner Cap (20) into the indi-
cated end of the weight tube on the Leg Lever
(6). Press a 25mm Round Angled Cap (17) onto
the other end of the weight tube.
Tap two 38mm Square Inner Caps (18) into the
Leg Lever (6).
Lubricate the M10 x 60mm Bolt (25) with grease.
Attach the Leg Lever (6) to the Front Leg (4) with
the Bolt and an M10 Nylon Locknut (31). Do not
overtighten the Locknut; the Leg Lever must
be able to pivot easily.
7. Press two 25mm Square Inner Caps (19) into a
Pad Tube (12). Slide the Pad Tube into the Leg
Lever (6). Slide two Foam Pads (13) onto the
ends of the Pad Tube. Make sure the Foam
Pads are oriented as shown.
Repeat this step with the other Pad Tube (12).
8. Press a 25mm Round Inner Cap (20) into a
Weight Rest (15). Insert the Weight Rest into an
Upright (1). Turn the Weight Rest so the locking
pin is wrapped around the Upright.
Repeat this step with the other Weight Rest
(15).
19
19
6
13
13
12
12
15
15
Locking
Pin
20
1
25
31
17
8
3
2
31
27
5
18
18
Lubricate
6
4
20
6
7