Filter
Top Products
9
2. Insert an M8 x 75mm Carriage Bolt (83) up
through the Stabilizer (3).
Attach the Base (1) and the two Weight Guides
(18) to the Stabilizer (3) with two M10 x 85mm
Bolts (81), two M10 Washers (80), two 21mm
Steel Spacers (108) and two M10 Nylon Locknuts
(77), and an M8 Nylon Locknut (78).
Make sure
the indicated holes in the Weight Guides are
nearer the bottom. Do not tighten the Nylon
Locknuts.
Attach the Upright (2) to the Base (1) with the two
indicated M8 x 75mm Carriage Bolts (83) and two
M8 Nylon Locknuts (78). Do not tighten the
Nylon Locknuts yet.
2
3
10
78
75
104
110
78
1
18
83
1
81
80
80
108
78
78
83
83
78
2
3
77
Holes
1
3. Attach the Front Leg (10) to the Base (1) with the
two M8 x 75mm Carriage Bolts (83) and two M8
Nylon Locknuts (78).
Do not tighten the Nylon
Locknuts yet.
Attach the Leg Lever Bumper (75) to the Front
Leg (10) with an M4 x 16mm Self-tapping Screw
(110) and an M4 Washer (104).
Make sure the
end of the Leg Lever Bumper is pointing up.
1.
Insert four M8 x 75mm Carriage Bolts (83) up
through the Base (1).
Note: It may be helpful to
place a piece of tape over each Bolt head to
hold it in place.
Before beginning assembly, make sure you
understand the information in the box on
page 8. See the PART IDENTIFICATION
CHARTS on pages 5 and 6 of this manual
for help identifying small parts.
Frame Assembly
83
8
3
1