Filter
Top Products
11
7. Attach a Shroud Cover (23) to the Left and Right
Shrouds (21, 22) with two M6 x 28mm Bolts (94),
f
our M6 Washers (114), and two M6 Nylon
Locknuts (107).
Attach the Shroud Cover (23) to the Top Frame
(4) with four M4 x 16mm Self-tapping Screws
(110) and four M4 Washers (104).
See the inset drawing and attach the other
Shroud Cover (23) in the same manner.
7
23
4
114
114
114
1
14
110
1
10
104
104
94
94
1
07
8. Note: Some parts have been removed to show
this step clearly.
Slide the two Weight Bumpers (71) onto the
Weight Guides (18). Orient nine Weights (19) with
the pin holes on the bottom as shown. Slide the
Weights onto the Weight Guides.
Insert the Weight Tube Cap (76) into the Weight
Tube (20). Insert the Weight Tube into the nine
Weights (19).
Make sure the pin on the Weight
Tube is oriented as shown.
Lubricate the indicated holes in a Weight (19)
with the included grease packet. Slide the Weight
onto the Weight Guides (18).
Attach the Weight Guides (18) to the Top Frame
(4) with an M10 x 155mm Bolt (96), two M10
W
ashers (80), two 13mm Steel Spacers (109),
and an M10 Nylon Locknut (77).
8
4
80
80
109
77
96
23
71
19
20
18
Pin
Pin
Hole
Grease
76