Filter
Top Products
Note: All numbers in this section refer to the Part List
and Exploded Drawing on the back cover.
Pull the Reed Switch Wire (8) out from the center post
(A) and plug it into the back of the Electronic Monitor
(7).
Gently push the Wire (8) back into the center post (A)
and slide the Electronic Monitor (7) onto the mounting
bracket (B) on top of the post.
Your Mini Stepper is ready to use.
Using the Electronic Monitor
If there is a piece of clear protective plastic on the
Electronic Monitor, remove it before operating the
Stepper. The Electronic Monitor will turn on when you
step onto the Pedals or push the MODE/RESET
Button (C).
The Monitor features four different modes to provide
you with instant exercise feedback:
¥ TIME displays the time you have exercised.
¥ COUNT shows the total number of steps in this
session.
¥ CALORIES shows the approximate number of
calories you have burned while exercising.
¥ SCAN displays the preceding three modes in a
repeating cycle, showing each mode for approxi-
mately five seconds.
You can manually select and hold each mode by
pressing the MODE/RESET Button until the desired
mode is displayed.
The Electronic Monitor will turn off automatically if nei-
ther the Pedals, nor the MODE/RESET Button are
used for a period of approximately five minutes.
Assembly
SCAN
TIME CALCOUNT
Using the Stepper
A
C
7
8
B
Replacing the Monitor Battery
The Electronic Monitor uses a type L1154 Watch
Battery (included).
To replace the battery, remove the screw on the back
of the Electronic Monitor and open the Monitor. Install
the battery into the holder in the same position as the
old battery. Assemble the Monitor.