Filter
Top Products
6
3
STEP
3
STEP
• Connect the right dual-action arm to
the right console mast rotation
housing, being sure to line up the
holes. Secure the dual action arm in
place with four screws (M8x30L) and
tighten with a 6
MM
T-handled Allen
wrench. Snap the dual action end
cap into place.
• Connect the right lower link arm to
the right dual-action arm by lining up
the holes on the end of each arm.
Slide the Link Arm Bushing into the
hole of the socket joint. Place a
washer (M10.5x18x2t) on the
capscrew (M10x40L) and slide the
capscrew through the hole. Place a
second washer followed by a nut
(M10) on the capscrew and tighten
using the 17
MM
socket wrench and 8
MM
L-shaped Allen wrench.
• Position the link arm cover into
place over the joint of the lower link
arm and dual-action arm. With a
screw (M5x12L) and Phillips
screwdriver, connect the two halves of
the cover through the hole located in
the front of the cover. Attach the cover
to each side of the lower link arm with
the two washers (M5.3x10x1t) and
two screws (M5x12L).
• Repeat these steps on the left side.
PINK BAG