Filter
Top Products
7
4
STEP
• X6000DA only: Unfold the RPM
sensor wire, located in the frame console
mast bracket. Remove any kinks.
• All models: Slide the rubber console
mast cover onto the bottom of console
mast, and slide it up as far as it will go.
• All models: Unfold the console cable
and attach it to the string located at the
bottom of the console mast. Guide the
wire up through the mast while
simultaneously sliding the console mast
onto the frame bracket.
• All models: Bolt the console mast
to the frame bracket with two bolts
(M8 x 60
MM
), two flat washers
(M8), and two lock washers (M8).
Tighten with the Blue 5
MM
Allen
wrench. Slide the rubber console mast
cover back down over the bolt heads.
X6000DA NOTE: Be sure the RPM
sensor wire exits through the small slot
at the top right side of the console
mast.
• X6000DA only: Install the batteries
in the console. Mount console to
console mast using the four screws.
Plug the RPM sensor wire into the
back of the console, and feed the
excess back down into the small slot
in the console mast.
• X6000DA only: Turn the tension
knob to Level 15. Reach inside the
console mast and connect the magnet
cables. Turn the knob to Level 1 and
mount the knob using a bolt (M5 x 25
MM
).
• X6200HRT/DA only: Remove the
four screws from the back of the
console. Plug the wire connector from
inside the mast into the console. The
cable connector is slotted, so it may
only be connected one way; do not
force it!
• X6200HRT/DA only: Mount the
console to the mast using the four
screws. Do not pinch the cable!
• All models: Bolt the water bottle
cage to the console mast using the
two bolts located in the mast.
GREEN BAG
X6200HRT/DA
X6000DA
X6000DA
Only
4
STEP