Filter
Top Products
2
STE P
• Slide the console mast boot onto the
console mast.
• Unfold the wire harness located
in the console mast frame bracket.
Connect it to the wire tie coming
from the bottom of the console mast.
Pull the wire tie and wire harness up
through the top of the console mast
while simultaneously sliding the mast
into the frame bracket.
• Secure the mast to the frame using
six lock washers (M8) and six bolts
(M8x15L). Tighten with the 5mm
T-shaped wrench. Place the seventh
bolt (M8x15L) in the rear of the frame
bracket and tighten until snug.
• Slide the console mast boot down
and set it in place on the side cover.
• Remove the nuts (M8) from the bot-
tom of the seat. Attach the seat to the
seat post with the nuts you just removed.
Tighten with the 15mm wrench.
B L U E B A G
3
STEP
• Feed the heart rate wires of the
handlebar through the small hole locat-
ed in the front of the console mast. Pull
these wires up through the hole at the
top of the console mast. Attach the
handlebar to the console mast using
four bolts (M8x20L). Tighten with the
5mm T-shaped wrench.
P I N K B A G
1
STEP
• Install the rear foot with four lock
washers (M8), two inside bolts
(M8x65L), and two outside bolts
(M8x20L). Tighten with the 5mm
T-shaped wrench.
O R A N G E B A G
A s s e m b l y
G u i d e
1
STEP
4
STEP
• Remove the four mounting bolts
from the back of the console and
four screws holding the console back
cover with the screwdriver. Plug in
the wire harness and the two heart
rate wires to the back of the console.
Attach the console to the console mast
with the four bolts removed earlier in
this step.
• Plug in the 9-volt battery. Re-attach
the console back cover with the four
screws removed previously.
• With the screwdriver, remove the
two bolts located half way up the con-
sole mast. Attach the accessory tray to
the console mast with the two bolts.
C O N S O L E
3
STEP
4
STEP
Handlebar
Rear Foot
Console Mast
Console Mast
Boot
Frame
Bracket
Heart Rate
Wires
Wire Harness
2
STEP
Accessory
Tray
Console
Console Back Cover
U70_AG_091111.indd 2 11/11/09 9:09 AM