Filter
Top Products
2
STEP
6
2
STEP
MODELS T9700HRT & T9700S: Slide
the data cables down the right
console support using the white wire
tie as a guide. Make sure that the
data cable (one large ribbon cable)
goes through the large hole in the
lower part of the console upright.
MODELS T9600HRT & T9500HRT:
Slide the data cables down the right
console support using the white wire
tie as a guide. Make sure that the
data cables (1 small & 1 large
telephone style cable) go through the
large hole in the lower part of the
console upright.
MODELS T9400HRT, T9300 &
T9200: Slide the data cables down
the right console support using the
white wire tie as a guide. Make sure
that the data cables (1 small & 1
large telephone style cable) come out
the bottom of the right console
support.
• Mount the console to the console
mast using four bolts (M8 X 20L) and
tighten with the blue-handled
5
MM
Allen wrench.
NOTE: Push all extra data cable into
the console mast. Make sure not to
pinch or cut the data cable.
• Mount the right-hand side mount
handlebar to the console mast using
two bolts (M8 x 135L). Repeat this on
the left-hand side.
BLUE BAG