Filter
Top Products
53
GENERAL
AUTO-CALIBRATION
(Models T9700S, T9700HRT, & PREMIER Only)
DO NOT STAND ON THE BELT WHEN PERFORMING THE AUTO-CALIBRATION!
You need to access User Engineering Mode to run the Auto Calibration.
To access this mode, please hold down SPEED DOWN and ENTER for 5
seconds. When in the User mode, "USER ENG" appears in the
alphanumeric window. Press ENTER. To access the data press either set of
arrow keys until "AUTO-CALIBRATION" appears. Press ENTER.
To begin auto-cal, press START. The Treadmill will run through minimum
and maximum speed and maximum incline; this will take 3-5 minutes. Let
the Treadmill perform this complete function before exiting the Engineering
Mode.
"END" will appear when the auto-calibration is complete. The Treadmill will
come to a complete stop and return to the start-up screen in the
alphanumeric window.
P22 - EXIT USER ENGINEERING MODE
P22 represents exit mode. When you press ENTER, the console performs
a reboot, returning to program setup.