Filter
Top Products
Assembly
Guide
To avoid possible damage to this Folding Treadmill, please follow these assembly steps in the correct order.
Before proceeding though, find your new Folding Treadmill’s 2 serial numbers, located on the
front of the main frame and on the bottom of the console, and enter here:
Refer to these numbers when calling for service, and also enter these serial numbers on your Warranty Card
and in your own records. Be sure to read your Owner’s Guide before using your new Folding Treadmill.
If any parts, hardware or tools are missing, please call 1.800.335.4348, Extension 12
NOTE: It is recommended that you apply grease to the threads of each bolt as you assemble your Folding
Treadmill, to prevent loosening and noise. Also, during each assembly step, ensure that ALL nuts and bolts
are in place and partially threaded in before completely tightening any ONE bolt.
1
STEP
• Slide on the right and left console
mast covers from the bottom of the
console masts
• Using the wire tie as a guide, slide
the data cables (One small and one
large) up from the bottom of the right
console mast. Make sure the data
cables run through the slot located at
the front of the right console mast.
• Put the console mast into the
console mast bracket. Be sure not to
pinch the data cables
• Secure the console mast to the
bracket with 4 bolts (M8x20L); 2 bolts
on each side. Tighten with the
enclosed 5mm Allen wrench
• Repeat on the left side
NOTE:
There are no data cables on
the left side.
ORANGE BAG
1
STEP
2
STEP
• Slide the left and right console mast
covers over the console mast brackets.
• Fold the treadmill
• Attach the right side cover using the
Flathead pointed screw for the rear of
the cover and the Flathead bolts for
the front of the cover.
• Repeat this step on the left side.
• Unfold the treadmill
BLUE BAG
2
STEP
3
STEP
• Plug the large data cable into the
large connector on the console. Plug
the small data cable into the small
connector on the console.
• Push the extra data cable into the
console mast. Be sure not to pinch the
data cables.
• Mount the console to the console
masts. Attach the console using four
bolts (M8x20L) and tighten using the
enclosed 5mm Allen wrench.
• Attach one handlebar to the right
console mast using two bolts
(M8x135L).
• Repeat on the left side
PINK BAG
6
STEP
T9250 AND T9450
FOLDING TREADMILLS
6
STEP
• If the running belt slips when used,
use the supplied 8mm Allen wrench to
turn the left and right tension bolts
clockwise
1
/4-turn at a time until the
belt no longer slips.
• Run the treadmill at 2.0 mph. If the
running belt is too far to the
right
side,
use the supplied 8mm Allen wrench to
turn the
right
tension bolt
clockwise
1
/4-turn at a time until the belt remains
centered during use.If the running belt
is too far to the
left
side, turn the
left
tension bolt clockwise
1
/4-turn at a
time until the belt remains centered
during use.
BELT TENSION
5
STEP
Please refer to back cover for this
procedure, then return to Step 6.
AUTO-CALIBRATION
3
STEP
4
STEP
Once your treadmill has been
positioned for use, you should lock the
four transport wheels located on the
lower folding frame. With your foot,
simply press down on the bottom
latch, labeled ON, of all four
transport wheels.
LOCK WHEELS
4
STEP
Frame Serial Number
Console Serial Number