Filter
Top Products
7
4
STEP
Once the treadmill is plugged in, you need to perform an Auto Calibration to assure maximum performance.
MODELS T9350 & T9450HRT:
DO NOT STAND ON THE BELT WHEN PERFORMING THE AUTO-CALIBRATION
• You need to access User Engineering Mode to run the Auto Calibration. To access this mode, please hold down
SPEED DOWN and SELECT for 5 seconds. When in the User mode, "USEr" displays in the center window. To
access the data press the ELEVATION keys until "Auto" appears in the center window. Press Start to select this
function.
• To begin auto-cal, press START. The treadmill will run through minimum and maximum speed and maximum
incline. This will take 3-5 minutes. Let the treadmill perform this complete function before exiting the Engineering
Mode.
• Elevation A/D or Elevation in % appears in the left window. PWM value or Speed appears in the right
window. "End" will appear in the center window when the auto-calibration is complete. When Auto-Calibration
is complete, it will take about 30 seconds to go to 0 elevation and return to the start-up screen with P1 showing
in the function window.
MODEL T9250:
DO NOT STAND ON THE BELT WHEN PERFORMING THE AUTO-CALIBRATION
• Hold the Elevation Up and Speed Down buttons for 5 seconds. The console will beep 5 times and a number
will appear in the window. Shortly thereafter, EnG1 will appear in the window. Press the Elevation Up or Speed
Up to EnG4
• Press Start. The treadmill will calibrate itself. It will take 3-5 minutes. When the Auto Calibration is complete
"END" will flash in the window. Wait 10 seconds.
• Remove the Safety Key. Then, put the Safety Key in place to use the treadmill.
AUTO CALIBRATION