Filter
Top Products
8
AH1
AC2
AC1
AB1
Acorn Nuts
1
STEP
• Place the rear base support (AC1) on
the floor with rubber pads on the bottom.
Slide the U-bracket of the main frame tube
(AB1) around the rear base support. The
wheels should be facing outward. Secure
this joint by securing two bolts (M10x72)
and two flat washers (10.2x25x2)
through the bracket and base support from
the bottom. Finish by adding two flat
washers (10.2x25x2) and two acorn nuts
(M10) to the top and tighten.
• Place the front base tube (AC2) on the
floor, rubber pads on the bottom. Make
sure it is oriented identical to the rear
support. Position the front end of the main
frame tube over the holes in the base
support. Insert two bolts (M10x68) and
two flat washers (10.2x22x2) from
the top. Attach and tighten two flat
washers (10.2x22x2) and two nuts (M10)
to the bottom.
• Place the accessory receiver tube (AH1)
against the face of the main frame tube
(AB1). Insert two bolts (M10x60), two flat
washers (10.2x22x2) and fasten two flat
washers (10.2x22x2) and two nuts (M10)
to the rear and tighten.
ORANGE BAG