Filter
Top Products
6
2
STEP
• Slide the rubber boot onto the
console mast.
• Locate the bundle of wires that
comes from the bracket on top of the
bike frame. Wrap these wires with the
wire tie coming from the bottom of the
console mast. Pull the wire tie and
bundle of wires up through the top of
the console mast while simultaneously
sliding the mast into the frame
bracket.
• Secure the console mast to the
frame bracket with six lock washers
(M8) and six screws (M8x15L).
Tighten with the 5
MM
Allen wrench.
Place the seventh screw (M8x15L) in
the rear of the frame bracket and
tighten until snug.
• Slide the console mast boot down
and snap it into place on the side
cover.
• Remove the nuts (M8) from the
screws on the bottom of the seat.
Attach the seat to the seat post with
the nuts you just removed. Tighten with
the 15
MM
wrench.
• Loosen the seat post knob and slide
the seat post into place in the seat
tube bracket.
BLUE BAG
2
STEP