Filter
Top Products
6
2
STEP
• Slide the rubber boot onto the
console mast.
• Unfold the wire harness located in
the console mast frame bracket.
Connect it to the wire tie coming from
the bottom of the console mast. Pull
the wire tie and wire harness up
through the top of the console mast
while simultaneously sliding the mast
into the frame bracket.
• Secure the mast to the frame using
six lock washers (M8) and six screws
(M8x15L). Tighten with the 5
MM
Allen
wrench. Place the seventh screw
(M8x15L) in the rear of the frame
bracket and tighten until snug.
• Slide the rubber boot down and
snap it into place on the side cover.
• Remove the nuts (M8) from the
bottom of the seat. Attach the seat to
the seat post with the nuts you just
removed. Tighten with the 15
MM
wrench.
• Loosen the seat post knob and slide
the seat post into place in the seat
tube bracket.
BLUE BAG
2
STEP