Filter
Top Products
Step 12 • Heart Rate Control Console Model
E3200HRC only.
This console is manufactured with an internal wireless telemetric
receiver that will receive heart rate signals sent to it by a transmitter
that is worn around your chest. This wireless technology is accurate,
continuous, and convenient. You should be positioned on the Fitness
Cycle seat for the system to operate.
1:
On the back side of your transmitter are two rubber strips several
inches long. These rubber strips are the electrodes that will pick up
the signals of your heart beat. It is very important to moisten these
strips with several drops of water prior to placing the belt against
your chest. This moisture will allow the signals to be conducted to the
transmitting hardware. If you ever use the bike and the display does
not show a heart rate value, remoisten the electrodes.
2:
You will get the best results if you wear the transmitter directly against
your skin. Once these electrodes are moistened, center the transmitter
just below the breast or pectoral muscles with the Vision Fitness logo
centered on the chest and facing out. Adjust the length of the elastic
belt so that the transmitter presses firmly against your skin, but not
so tight as to be uncomfortable. The transmitter will begin sending a
signal as soon as it is worn.
3:
Check for heart rate feedback by testing the console in Heart Rate
mode. Pedal the Elliptical Trainer to confirm that the console is picking
up the signal from the transmitter.
LOGO
E3200HRC Operation