Filter
Top Products
:: 5
Fasten the pedal straps so that the Tunturi logo faces outward. Select
strap tightness, set the appropriate strap hole on the retainer from below
and pull forcibly upward. Especially when the equipment is new, the
strap fastening may seem relatively tight.
T.I.E. INTERFACE
Push the T.I.E. interface module carefully into place at the top of the
handlebar support tube. The loose screws hanging from the metal
fastening plate on the bottom of the T.I.E. module must enter the holes
at the top end of the handlebar. Make sure that the module is correctly
in place and tighten the fastening screws. (Please see the illustrations in
the T.I.E. manual.)
Read the T.I.E. manual carefully before you start to exercise.
POWER CORD (FIGURE 6)
Before connecting the device to a power source, make sure that local
voltage matches that indicated on the type plate: the T4/T6 operates at
either 230 V or 115 V (North American version). Plug the socket end of
the power cord into the connector, just above the rear support in the
centre of the frame, and the other end into the wall socket. Turn on the
power from the switch above the connector.
NOTE!
:: The device must be connected to a grounded wall socket. Do not
use extension wires when connecting the device to the power
source.
:: Make sure the power cord does not run underneath the device.
:: DANGER: Always switch off the power and uplug this appliance
from the electrical outlet immediately after using.
:: WARNING: To reduce the risk of burns, fire, electric shock, or
injury to persons:
1) An appliance should never be left unattended when plugged in.
Unplug from outlet when not in use, and before carrying out any
maintenance or repair procedures.
2) Do not operate under blanket or other combustive material.
Excessive heating can occur and cause fire, electric shock, or
injury to persons.