Tunturi C4 Elliptical Trainer User Manual


 
4
OWNER'S MANUAL
C4
FOOTRESTS
Attach the footrests to the position of your choice
on the pedal shafts with two screws, two washers /
screw and locking nuts.
METER AND HANDLEBAR
Remove the two attachment screws at the back
of the meter and the rubber band holding the
handlebar pulse cable. Attach the cable coming
from the front frame tube and the pulse cable
to the connectors of the meter. After connecting
the cables, thread them into the front tube. Lead
the pulse cable out through the hole in the front
tube. Push the meter into place on top of the front
frame tube and attach it with the two attachment
screws: do not damage the meter cable! Attach the
handlebar to the front frame tube with a clamp,
four screws and two sleeves / screw.
TRANSFORMER
Before connecting the equipment to a power
source, make sure that local voltage matches that
indicated on the type plate: the equipment operates
at either 230 V or 115 V (North American
version). Plug the socket end of the transformer
cord into the connector, just above the rear support
in the center of the frame, and the other end into
the wall socket.
NOTE! The equipment must be connected to a
grounded wall socket. Do not use extension wires
when connecting the equipment to the power
source. Make sure the power cord does not run
underneath the equipment.
DANGER: Always switch off the power and
unplug this appliance from the electrical outlet
immediately after using.
WARNING: To reduce the risk of burns, fi re,
electric shock, or injury to persons:
1) An appliance should never be left unattended
when plugged in. Unplug from outlet when not in
use, and before carrying out any maintenance or
repair procedures.
2) Do not operate under blanket or other
combustive material. Excessive heating can occur
and cause fi re, electric shock, or injury to persons.
ADJUSTING THE FOOTREST SUPPORTS
(EUROPEAN MODEL)
Tu rn the locking knob counterclockwise and pull
the locking knob out so that the adjusting tube can
be moved freely up and down. When the height is
right, let go of the knob. The tube locks into place.
Tighten the locking knob clockwise.
NOTE! Always make sure that the locking knob is
fastened properly before starting to exercise. Adjust
the footrest support height so that the elliptic
movement does not strain your ankles.
EXERCISING
When you’ve not exercised for a long time,
you should have your condition checked and
consult a doctor, if you are over 40, your physical
condition is poor, you suffer from a chronic illness
or have health problems, or you have injuries
to or problems in your muscles. For endurance
exercising, it’s good to exercise at least 3 times a
week, but remember for your health that once
a week is better than not at all. The effects of