Filter
Top Products
Quartz Chronographs G10/G15
*
www.tissot.ch
134_EN / 05.07
2/5
Standard model
Usage / Settings
Models with a screwed crown
To ensure even better water-resistance, some models are fitted with a screwed down crown. Before setting the time or date, you must first unscrew the crown into position
IB
before you can pull it out into position
II
or
III.
Important: After every operation, the crown must be screwed back down firmly to protect the seal integrity of the watch.
Setting the time
Pull the crown out to position
III
and turn it clockwise or counterclockwise to set the desired time. Synchronize the small seconds hand at the 6 o'clock position
with an official time signal (radio/TV/Internet) by pulling out the crown to the second notch; the hand will then stop. Once the time has been synchronized, push the
crown back into position I (and screw it back on models with a screwed crown).
Winding
Quartz chronographs never need to be wind.
Fast correction of the date
Pull the crown out to its first stop (position
II
) and turn it counterclockwise until the correct date is displayed.
Congratulations
We congratulate you on choosing a chronograph from TISSOT
®
, one of the most highly renowned Swiss brands in the world. Meticulously designed, using only the
highest quality materials and components, your chronograph is protected against shock loads, variations in temperature, water and dust.
This User's Manual is valid for standard TISSOT® quartz chronographs for ladies (G15 movement) and men (G10 movement), and for chronographs with retrograde
function. For the settings and operation of your chronograph, please refer to the instructions corresponding to your model.
Your chronograph allows you to time events lasting up to 30 or 60* minutes, and offers you the following functions:
– Standard START–STOP function
– ADD function (partial times)
– SPLIT function (intermediate times)
To enable your chronograph to give you many years of perfect precision service, we recommend that you follow the advice contained in this booklet very carefully.
* Retrograde model
Resetting the counters
The counters must be zeroed before starting timing. If necessary, proceed as follows:
• Zero the 30 minutes (or 12 hours) counter hand:
- Gents G10: crown in position
III
, pusher
A
- Ladies G15: crown in position
II
, pusher
B
• Zero the 60 seconds counter hand:
- Gents G10: crown in position
II
, pusher
B
- Ladies G15: crown in position
III
, pusher
A
• Zero the 1/10th of a second counter hand:
- Gents G10: crown in position
II
, pusher
A
- Dames G15: crown in position
III
, pusher
B
20