Timex W-3 Watch User Manual


  Open as PDF
of 3
 
ALARM AND CHIME
A. Press MODE to select ALARM
B. Press SET to select Time Zone 1 or 2
C. Press START/SPLIT to change.
D. Press MODE to select HOURS. Digits will flash.
E. Press START/SPLIT to advance. Go through 12 hours for AM or PM
F. Pr ess MODE to select TENS of MINUTES.
G. Press START/SPLIT to advance. Repeat for MINUTES, Time Zone 1 or 2.
H. Press SET when done.
I. In ALARM Mode, press START/SPLIT repeatedly to turn ALARM and CHIME modes on or off.
When alarm time is indicated in appropriate time zone, watch will beep for 20 seconds, or until
a watch button is pushed. Alarm will repeat every 24 hours until deactivated.
COUNTDOWN TIMER
A. Press MODE to select TIMER
B. Press SET to select TENS of HOURS. Digits will flash.
C. Press START/SPLIT to advance.
D. Press MODE to select HOURS.
E. Repeat to set TENS of MINUTES, MINUTES,TENS of SECONDS, and SECONDS
F. Pr ess SET when done.
G. Press START/SPLIT to start timer.
H. Press STOP/RESET to pause, START/SPLIT to resume.
I. Press STOP/RESET again to reset.
Watch will beep when countdown ends.
TIME ZONE
A. Press MODE to select TIME ZONE 2.
B. Press and hold SET to set time. HOURS digits will flash.
C. Press START/SPLIT to advance. Go through 12 hours for AM or PM.
D. Press MODE to select MONTH, DATE, 12- or 24-hour TIME display. Press START/SPLIT to
advance.
E. Press SET when done
F. Pr ess START/SPLIT to view TIME ZONE 2.
INDIGLO® NIGHT-LIGHT WITH NIGHT-MODE®
A. Press INDIGLO to illuminate watch face. Patented (U.S. pat. 4,527,096 and 4,775,964) elec-
troluminescent technology used in the INDIGLO® night-light illuminates entire watch face
at night and in low light conditions.
B. Press and hold INDIGLO for three seconds (beep will sound) to activate or de-activate
NIGHT-MODE®
C. While in NIGHT-MODE®, press any button to illuminate watch face for 3 seconds
If your watch is water-resistant, meter marking or ( ) is indicated.
Water-Resistance Depth p.s.i.a.* Water Pressure Below Surface
30m/98ft 60
50m/164ft 86
100m/328ft 160
200m/656ft 284
*pounds per square inch absolute
WATER RESISTANCE
WARNING: TO MAINTAIN WATER-RESISTANCE, DO NOT PRESS ANY BUTTONS OR PULL
OUT THE CROWN UNDER WATER UNLESS YOUR WATCH IS INDICATED AS 200 METER
WATER-RESISTANT.
1. Watch is water-resistant only as long as crystal, crown and case remain intact.
2. Watch is not a diver watch and should not be used for diving.
3. Rinse watch with fresh water after exposure to salt water.
 previous