Filter
Top Products
TIMER
1. Press MODE repeatedly until TIMER appears.
2. Press SET/RECALL. Hour digits flash.
3. Follow same pattern as setting TIME and ALARM to set hours, minutes, seconds, and select
between REPEAT/AT END (timer counts down and then repeats) or STOP/AT END (the timer
counts down and then stops).
4. Press DONE to confirm and exit.
5. Press START/SPLIT to start TIMER. Timer will continue to run even if you exit Timer mode.
If REPEAT/END selected will flash. If STOP/END selected will flash.
6. An alarm melody will chime when the timer has reached zero or before it starts to count
down again.
7. Press STOP/RESET to stop TIMER. Press again to reset to countdown timer.
CHRONO
If your watch is water-resistant, meter marking or ( ) is indicated.
Water-Resistance Depth p.s.i.a.* Water Pressure Below Surface
30m/98ft 60
50m/164ft 86
100m/328ft 160
*pounds per square inch absolute
WATER & SHOCK RESISTANCE
INDIGLO® NIGHT-LIGHT/NIGHT MODE® FEATURE
Press INDIGLO button to activate night-light. Patented (U.S. pat 4,527,096 and 4,775,964) elec-
troluminescent technology used in INDIGLO® night-light illuminates entire watch face at night
and in low light conditions. While the night-light is on pressing any button keeps it on for three
seconds.
Press and hold INDIGLO button for 4 seconds to activate NIGHT-MODE® feature (U.S. pat.
4,912,688). Moon icon will appear. Once activated, any button pushed will cause INDIGLO®
night-light to stay on for 3 seconds. NIGHT-MODE® feature will stay activated for 8 hours or
until deactivated by pressing and holding INDIGLO again for 4 seconds.
WARNING: TO MAINTAIN WATER-RESISTANCE, DO NOT PRESS ANY BUTTONS UNDER WATER.
1. Watch is water-resistant only as long as lens, push buttons and case remain intact.
2. Watch is not a diver watch and should not be used for diving.
3. Rinse watch with fresh water after exposure to salt water.
4. Shock-resistance will be indicated on watch face or caseback. Watches are designed to pass
ISO test for shock-resistance. However, care should be taken to avoid damaging crystal/lens.
1. Press MODE until CHRONO appears.
2. Press and hold SET/RECALL.
3. The Display will read: FORMAT/SET, then LAP/SPL or SPL/LAP.
4. Press + or – to select desired format.
5. Press DONE to confirm and exit.
6. To use chrono, press START/SPLIT. Chrono continues to run even if you exit the mode.
7. Press STOP/RESET to stop chronograph from running OR while chrono is running, press
START/SPLIT to take a split. Lap and split times will then be displayed in the format you
selected. The lap number will alternate with the last two digits of the bottom line.
NOTES:
• Lap and split times will appear frozen for 10 seconds. Press MODE to release the display and
see running chrono.
• While chronograph is running or stopped, press SET/RECALL, then press + or – to scroll
through stored laps or to recall stored laps/splits. Press SET/RECALL again to return to run-
ning chronograph.
• Press and hold STOP/RESET to reset chronograph.