Timex W-107-US Watch User Manual


  Open as PDF
of 3
 
COUNTDOWN TIMER
To set timer:
1. Press MODE repeatedly to select TIMER mode.
2. Press and hold ADJUST for 2 seconds to set. Minute digits blink.
3. Press FORWARD or REVERSE to set digits.
4. Press MODE. Hour digits blink.
5. Press FORWARD or REVERSE to set digits.
6. Press ADJUST to confirm and exit.
Press FORWARD to start countdown. Press again to stop or resume countdown.
Press REVERSE to reload the pre-set value (1 hour at time of purchase).
STOPWATCH
1. Press MODE repeatedly to select STOPWATCH mode.
2. Press FORWARD once to start stopwatch.
3. Press FORWARD at any time to stop counting. Press again to resume.
4. To clear, press FORWARD to stop counting. Press REVERSE to clear.
To use split function:
1. Press REVERSE while stopwatch is running to view lap time. The minute/hour symbols
(e.g., 2’33”) flashing indicates stopwatch is still running in background.
2. Press REVERSE again to display accumulated time. Stopwatch will count up to 1 hour before
starting from zero again.
If your watch is water-resistant, meter marking or ( ) is indicated.
Water-Resistance Depth p.s.i.a.* Water Pressure Below Surface
30m/98ft 60
50m/164ft 86
*pounds per square inch absolute
WATER RESISTANCE
WARNING: TO MAINTAIN WATER-RESISTANCE, DO NOT PRESS ANY BUTTONS UNDER WATER.
1. Watch is water-resistant only as long as lens, push buttons and case remain intact.
2. Watch is not a diver watch and should not be used for diving.
3. Rinse watch with fresh water after exposure to salt water.
INDIGLO® NIGHT-LIGHT
Press INDIGLO® to activate night-light. Patented (U.S. pat 4,527,096 and 4,775,964) electrolumi-
nescent technology used in INDIGLO® night-light illuminates entire watch face at night and in
low light conditions. While the night-light is on pressing any button keeps it on for three seconds.
See alarm section to turn Flashing INDIGLO® on/off.
MEMO MODE
You can set a memo to appear when the alarm goes off. Set up to seven messages with alarm
times. Each message can be a maximum of 20 characters.
To enter memo:
1. Press MODE repeatedly to enter MEMO mode.
2. Press FORWARD to view next memo (-1, -2, -3 …-7)
3. Press and hold ADJUST for 2 seconds to set.
4. Press FORWARD or REVERSE to select letter and start to spell your message.
5. Press MODE to proceed to next letter.
6. When the message is complete, press MODE repeatedly until the hour digit blinks (you must
toggle through 20 characters). Set alarm as you did in the above section.
7. Press ADJUST to confirm and exit.
8. Press REVERSE to turn alarm on/off for current memo (ALARM will appear/disappear).
7. Press FORWARD once to turn alarm on ( will appear), twice to turn chime on
( will appear); three times to turn
both on, four times to turn both off.
8. Press any button to silence alarm or chime.
To enable/disable INDIGLO® night-light to flash when alarm beeps, in any mode:
9. Press and hold INDIGLO for 2 seconds. Indicator will appear/ disappear respectively.
 previous