Timex Reebok Watch User Manual


  Open as PDF
of 3
 
INDIGLO® NIGHT-LIGHT
Press crown to activate light. Patented (U.S. pat. 4,527,096 and
4,775,964) electroluminescent technology used in the INDIGLO® night-
light illuminates entire watch face at night and in low light conditions.
If your watch is water-resistant, meter marking or ( ) is indicated.
Water-Resistance Depth p.s.i.a.* Water Pressure Below Surface
30m/98ft 60
50m/164ft 86
100m/328ft 160
200m/656ft 284
*pounds per square inch absolute
WATER RESISTANCE
WARNING: TO MAINTAIN WATER-RESISTANCE, DO NOT PRESS ANY BUTTONS OR PULL
OUT THE CROWN UNDER WATER UNLESS YOUR WATCH IS INDICATED AS 200 METER
WATER-RESISTANT.
1. Watch is water-resistant only as long as crystal, crown and case remain intact.
2. Watch is not a diver watch and should not be used for diving.
3. Rinse watch with fresh water after exposure to salt water.
4. Shock-resistance will be indicated on the watch face or caseback. Watches are designed to
pass FTC test for shock-resistance. However, care should be taken to avoid damaging crystal.
BRACELET ADJUSTMENT
FOLDOVER CLASP BRACELET
Find spring bar that connects bracelet to clasp. Using a pointed tool (Fig. 1), push spring bar in
and gently twist bracelet to disengage. Determine wrist size, then insert spring bar in correct
bottom hole (Fig. 2). Push down on spring bar, align with top hole and release to lock in place
(Fig. 3).
Bracelet Link Removal
Removing Links: Place bracelet upright and insert pointed tool in
opening of link. Push pin forcefully in direction of arrow until link is
detached (pins are designed to be difficult to remove). Repeat until
desired number of links are removed.
Reassembly: Rejoin bracelet parts. Push pin back into link in
opposite direction of arrow. Press pin down securely into bracelet
until it is flush.
SOLID LINK BRACELET
Removing Links: Using a very small screwdriver, remove
screws by turning COUNTERCLOCKWISE. Repeat until desired
number of links are removed. Do not remove links adjacent to
clasp.
Reassembly: Rejoin bracelet parts and insert screw in end of
opening where it was removed. Turn screw clockwise until
tight and flush with bracelet.
Fig. 1
Fig. 2
Fig. 3
 previous