Filter
Top Products
9
EN
Usage 7. Battery replacement
The display fades as the battery runs down. Replace the LR44 battery promptly.
1. Remove the back cover
Use a small Philips screwdriver to remove the 4 case screws
from the back of the case, then remove the inner ring and the
back cover.
* Handle the screwdriver and any other tools with care.
2. Remove the battery contact plate
Remove the two screws fastening the battery contact plate,
then remove the contact plate.
3. Replace the battery
Take out the old battery and insert a new one (LR44).
4. Fasten the contact plate back in its original position
Put the contact plate back in its original position and screw it
securely into place.
5. Attach the back cover
Fit the inner ring into the groove in the body so that it does
not slip out of position, then fit the cover from above. Finally,
fasten the cover securely with the four case screws.
Notice
• If you replace the battery yourself, your guarantee may not
cover splash resistance, due to misplacement of components,
etc. Check the procedures and positions of components, etc. thoroughly.
• Always reset the system after removing or replacing the battery.
Main specifications
* It is not possible to switch between centimeter and inch versions.
Centimeter version Inch version
Setting range 20 - 150 cm 10 - 60 inches
Body weight 20 -150kg 50 - 300 lb
Display content
Distance
Min. 0.01 km,
Max. 999.99 km
Min. 0.01 mile,
Max. 999.99 mile
Steps Min. 1 step, Max. 99,999 steps
Time 12-hour display
Calorie consumption Min. 0.1 kcal, Max., 9999.9 kcal
Walking time Min. 1 m, Max. 19h, 59 m.
Power supply DC1.5V (LR44 x1)
External dimensions
D13.5 x W42.7 x H54.2 mm
* Excluding band
Weight Approx. 40 g
Case
Philips
screws
Contact
plate