Star Trac IP-L5002 Fitness Electronics User Manual


 
STEP #3 – ASSEMBLE CAM ASSEMBLY AND LEVERAGE CURL ARMS :
1. Slide one of the CAM ASSEMBLYS onto the mount of the Main Frame as shown, the side of CAM ASSEMBLY that
has shaft slide onto the mount first.
2. After the CAM ASSEMBLY has been slid onto the mount, slide one of the LEVERAGE CURL ARMS onto the
corresponding shaft of the CAM ASSEMBLY as shown below, At the same time, align the hole of the shaft with the hole of
the mount of the LEVERAGE CURL ARMS, using one (M8x50mm SHOULDER BOLT), one (M6 FLAT WASHER), and
one (M6 NYLOCK NUT), then install one END CAP and one (M8x20mm SOCKET HEAD BOLT). Do not tighten these
bolts at this time.
3. Repeat step 1 thru 2 with the remaining CAM ASSEMBLY and LEVERAGE CURL ARM as shown below.
Page 14
STEP #3 Completed