Filter
Top Products
1
12 STAR
TRAC
E
SERIES
BIKES
OWNER’S
MANUAL
ASSEMBLY AND SETUP E-RB
UNPACKING
NOTE: Do not remove the base from the shipping carton at this time.
Remove the top cover from the shipping carton. Remove all parts and shipping supports (except the base) from the carton, and
verify that the following parts are included in your shipment:
Description Qty
Base 1
Display Weldment 1
Neck Tube 1
Seat Assembly 1
Bolt, Allen Head, M8 x 16 mm 4
Handlebar Assembly 1
Description Qty
Washer, M8 4
Bolt, Allen Head, M6 x 65 4
Star Washer, M6 4
Bolt, Allen Head M10 x 10 4
Washer, M10 4
This owners manual and the warranty card are also included in the packaging.
Note: This manual cover installation of the LED display. If you ordered a PVS kit or an
Embedded Display, please refer to the assembly and operating instructions included with those
products for proper setup and operation of the display assembly.
TOOLS REQUIRED
Your STAR TRAC E- RB can be assembled using the following tools:
Metric Hex Key Wrenches
Metric Open-End Wrenches
Metric Ratchet Socket Wrench Set
Torque Wrench
Phillips Head Screwdriver
ASSEMBLY
1. Unpack and Position the Base
Cut the long edge of the shipping carton base at both ends.
Fold the flap down to make a ramp.
With the aid of a helper, lift the rear end of the base, and
roll the base off of the shipping carton platform. Place the
base on the floor in the location where the unit will be
used. Be sure the chosen location is level.
Step 1